Page tree

Contact: sales@inno-maker.com / support@inno-maker.com /
Download: wiki.inno-maker.com

Skip to end of metadata
Go to start of metadata
ItemWIKI SKUCategoryPictureDescriptionPackageSPQ
AUDIO
1

HIFI DAC HAT

Audio

  • 1.Support Raspberry Pi Zero,Zero W,3B,3B+,PI4 with the 40-pin connector.                                                                 
  • 2.Support OSMC, Max2Play, RuneAudio, Volumio, Moode, PiCorePlayer, PiMusicBox, OpenELEC, Debian, Ubuntu etc. 
  • 3.Support play music from a hard disk or over the network. Support DSD over PCM(DOP)mode.  
  • 4.Class-leading stereo audio DAC PCM5122, sample rates up to 384-KHz/32-Bit. Paired with stereo high fidelity headphone amplifier TPA6133. Provides 2.1Vrms ground-centered outputs coupled with Film capacitor.


2

HIFI AMP HAT

Audio

  • 1.Support Raspberry Pi Zero,Zero W,3B,3B+,PI4 with the 40-pin connector.                            
  • 2.Support OSMC, Max2Play, RuneAudio, Volumio, Moode, PiCorePlayer, PiMusicBox, OpenELEC, Debian, Ubuntu etc.
  • 3.On-board TAS5713 is a 25-W Class-D digital-audio power amplifier for driving stereo bridge-tied speakers. Offers low distortion and acoustically accurate audio reproduction.
  • 4.Accept a wide range of input data 8-Khz to 48-Khz, Up to 90% Efficient, Supports speakers 4 Ohm impedance allows you to enjoy high quality audio.


3

SKYLARKI-UAC2912

Audio

  • 1.High Quality Audio Card support stereoscopic output and Single channel MIC input
  • 2.Support Windows,Mac OS,Linux


4

SKYLARKII-DAC5122BT

Audio

  • 1. Class-leading stereo audio DAC PCM5122, sample rates up to 384-KHz/32-Bit. Paired with stereo high fidelity headphone amplifier TPA6133.                                                                                         
  • 2. Build-in CSR8675 chip, latestversion Bluetooth 5.0 technology , with APTX-HD/ATPX-LL/AptX/AAC/LDAC codec, ability to deliver CD-like quality. Compatible with earlier version of Bluetooth devices.


5SKYLIIIAudio
Cooming Soon

Cameras
6

CAM-OV5647

Camera

  • 1.a low-cost fisheye lens wider field view camera module that designed for Raspberry Pi 4, Pi 3 B+, Pi 3, Pi 2, Pi B+, Pi A, Pi Zero.
  • 2.The board size is the same 39 x 39 mm .


7

CAM-MIPIOV9281

Camera

  • 1.OmniVision OV9281 Sensor,  It is a fully V4L2 compatible device                                                           
  • 2.Sensor size: diagonal 1/4 
  • 3.Sensor ADC Resolution: 8Bit/10Bit 
  • 4.CSI-2 output: 2 lanes/RAW8 or RAW 10 
  • 5.Pixel Count:1280 x 800


8

CAM-MIPI290MONO

Camera

  • Sensor type: SONY STARVIS IMX290LLR Black and white CMOS with 2.07M pixel.
  • Sensor size: diagonal 6.46 mm (Type 1/2.8)
  • Sensor ADC Resolution: 10Bit/12Bit
  • CSI-2 output: 2 lanes/RAW10 or RAW 12


9

CAM-MIPI327RAW

Camera

  • Sensor type: SONY STARVIS IMX327LQR color CMOS with 2.07M pixel.
  • Sensor size: diagonal 6.46 mm (Type 1/2.8)
  • Sensor ADC Resolution: 10Bit/12Bit
  • CSI-2 output: 2 lanes/RAW10 or RAW 12
  • Pixel Count:1920 x 1080
  • Pixel Size: 2.9(H)x2.9(V)um
  • CSI-2 default speed: 891Mbps/lane
  • Output modes: streaming mode
  • Shutter resolution: 1 horizontal unit
  • Gain: 0—72dB


10

MIPI CAM 327 OR MIPI CAM 290,With ISP

Camera

  • 1. 1/2.8 inch 2 Mega STARVIS Mega STARVIS sensor IMX327 by SONY, ISP 1080p@30fps,IR-CUT Circuit
  • 2.  Support  Raspberry Pi 3/3B/3B+/4B/Zero/Compute Module,Nvidia Jetson Nano / TX2  Uncompressed UYVY format,
  • YUV422-8bit
  • Standard lens mount
  • IR-CUT circuit


Industrial
11

USB CAN

Industrial

  • 1.Compatible with ARM BOARD,Linux,Android,Windows 32/64,MaxOS
  • 2.Plug and Play USB device. No external power required. Support wider CAN baud rate, From 20Kbps to 1Mbps can be programmed arbitrarily.
  • 3.On board STM32F0 microcontroller, high speed data transfer with DMA technique. Support for CAN bus 2.0A and 2.0B specification.
  • 4.Power supply isolation, signal input/output isolation, Built-in surge and static protection. 120 Ohm resistor selectable jumper feature.
  • 5.Comes with C/Python demos of Socket-CAN, detailed user manual and friendly technology support.


12

RS485 CAN MODULE


Industrial

  • 1.Compatible with Raspberry Pi Zero/Zero W/2B/3B/3B+/4.
  • 2.Only a small amount of GPIO are used and the remaining pins allow to work for other extended function
  • 3.Power supply and signal transmission isolation, Build-in surge and ESD protection.
  • 4.CAN function: on-board CAN controller MCP2515 via SPI interface, high speed CAN transceiver, digital isolation      ADUM1201BRZ, and communication Rates 20Kbps-1Mpbs can be programmed arbitrarily.
  • 5.RS485 function: on-board controlled via UART, half-duplex communication, supports automatically TX/RX switch without extra programming, on-board SPI to RS485 SC16IS1752 Electrical data isolation with ADI ADM2483.
  • 6.On-board individual 120 Ohm terminal resistance, Impedance matching and guarantee the ability to drive.
  • 7.On-board User ATC24C32 EEPROM,


13

USB LOGIC ANALYZER

Industrial



14

Armor case for Rasp Pi 4B

Industrial

  • 1.Excellent Heat Radiation
  • 2.Durable Metal , easy installing this heatsink case to your Raspberry Pi 4 B
  • 3.Comes with a PCB to show the pin map of Raspberry Pi4 to help you much easier to identify the GPIO
  • 4.Comes with 3 pieces thermal pads (the thickness is only 0.5mm) to touch the shell body to dissipate heat. 


15

RJ45/8P8C

Industrial

  • 1) RJ45/8P8C breakout board for Ethernet/DMX512/RS485/RS422/RS232.
  • 2) Board size: 53.6mm*60.45mm.
  • 3) Onboard 6 mounting hole.
  • 4) Come with 2 PCS PCB DIN Rail Mounting Adapter Circuit Board Mounting Bracket Holder Carrier Clips, fit for 35mm/15mm DIN rail.
  • 5) High quality and flexible.



Micro Chip R-W ClipIndustrial




Displays
16

0.96 INCH IIC SERIAL OLED

Display

 

  • 1.Support Raspberry Pi Zero, Zero W, 3B, 3B+,PI4  STM32, Ardunio, Beaglebone Black and any microcontroller which has IIC interface.
  • 2. Driver IC: SSD1306 , the LCD display is made of 128×64 individual OLED pixels.
  • 3.Comes with detailed documents, three kinds of ASCII character library, annotated sources and friendly technology support.


17

3.5 INCH DISPLAY

Display

  • 1.Compatible with Raspberry Pi Zero,Zero W,3B,3B+,PI4 via the 28-pin connector, With 480 (W) *320(H) Pixels high-resolution;
  • 2.Communication between the screen and the Raspberry Pi is interfaced with a high speed 63Mhz SPI connection. Enable the direct memory access(DMA) channel for high-speed data transmission in the kernel, so it can support output higher frame rate than other.
  • 3.On-board capacitive touch controller, allow you to control your raspberry PI by touching the screen with your fingers , Accurate and easy operating.
    4 On-board extremely accurate I2C real-time clock (RTC) DS3231 and continuous timing battery backup.


  • No labels
Write a comment…